Bonding unit for hotmelt or reactive hotmelt to process material out of 200 litre drums. The monoflow 200 thermo unit is especially developed for usage of hotmelt and reactive hotmelt. This is the right model for those who start up with hand application. It can easily be integrated into a semi or fully automatic machine later on, depending on your requirements. Technical data: outflow max. 2500 g/min.* compressed air requirement 6 bar, 600 l/min. power supply 3 x 400V+N+PE/ approx. 3 kW dimensions l x w x h 1500 x 1000 x 1800 mm weight approx. 600 kg *depending on viscosity, temperature, batch of material etc. Standard equipment*: Siemens S7-1200 / touch panel / ethernet-ready for integration in future automation 5 heating circuits (following plate, pump, back pressure regulator, hose, gun) 4 m heated high pressure hose (water vapour diffusing resistant) signal light (visual alert for system messages) material shortage control residual materials optimized following plate day and week timer pressure regulator to minimize pulsation two hand safety control *depending on the project, positions can differ Additional equipment: additional heading circuits swivel arm systems hydraulic model for higher outflow teflon-coated following plate for 200l drum working-hose prolongation special painting mobile unit, with wheels more options on request

Bonding unit for hotmelt or reactive hotmelt to process material out of 20 litre hobbocks. The monoflow 20 thermo unit is especially developed for usage of hotmelt and reactive hotmelt. This is the right model for those who start up with hand application. It can easily be integrated into a semi or fully automatic machine later on, depending on your requirements. Technical data: outflow max. 2500 g/min.* compressed air requirement 6 bar, 600 l/min. power supply 3 x 400V+N+PE/ approx. 3 kW dimensions l x w x h 600 x 400 x 1300 mm weight approx. 250 kg *depending on viscosity, temperature, batch of material etc. Standard equipment*: Siemens S7-1200 / touch panel / ethernet-ready for integration in future automation 5 heating circuits (following plate, pump, back pressure regulator, hose, gun) 4 m heated high pressure hose (water vapour diffusing resistant) signal light (visual alert for system messages) material shortage control mobile unit, with wheels day and week timer pressure regulator to minimize pulsation two hand safety control *depending on the project, positions can differ Additional equipment: additional heading circuits hydraulic model for higher outflow swivel arm system teflon-coated following plate for 20l drum more options on request

This Hot Melt Extruder is designed to be cost-effective and very easy in sealing of insulating glass units. Almost immediately after the application of the secondary seal the insulating glass units can be processed, due to the material properties of the Hotmelt. The processing parameters of the various Hotmelt adhesives are stored in the control panel and can be selected with the help of a predefined list in the input panel. Technical data: average production approx. 190 units /day tank capacity 20 litre outflow 0-2 kg/ min.* dimensions l x w x h 728 x 380 x 1158 mm weight approx. 100 kg power supply single phase 220/230V electrical power 13Amp/2.3kW number heating zones 4 zone *depending on viscosity, temperature, batch of material etc. Standard equipment*: steel frame, powder coated programmable control panel temperature control (under/ over temperature) material procurement monitoring programmable timer for pre-selection of preheating time cable-hose assembly with big hose cross section low-pressure gun with “Cool-touch” plastic housing gun with swivel joint for comfortable handling external gun cable fitted outside the cable-hose assembly for easy removal robust spiral spring for the protection of the cable-hose assembly mobile unit on wheels *depending on the project, positions can differ Additional equipment: pneumatic clamping table handguns for plugging the small gas filling holes precision-digital-thermometer more options on request